Cut-Weld-Drive Forums

Cut-Weld-Drive Forums (http://volksrods.com/forum/index.php)
-   The Cutting Board (http://volksrods.com/forum/forumdisplay.php?f=5)
-   -   Valve guide lube. (http://volksrods.com/forum/showthread.php?t=38600)

Amber 74 October 8th, 2017 11:40 AM

Valve guide lube.
 
Getting ready to reassemble my new heads after gasket port matching, polishing the combustion chambers and the exhaust ports and lapping the valves for a proper seat . The manual that I have says put white molybdenum - disulphide grease on the valve stems . The best I can find on this grease it seems to be an antiseize of some kind. Is this the best to use or is there something better to use .

rostigbug October 8th, 2017 11:43 AM

Re: Valve guide lube.
 
You are overthinking this.
I use assembly lube if I have some.
I have also used plain old wheelbearing grease

V8Transporter October 8th, 2017 01:23 PM

Re: Valve guide lube.
 
^^ There you go. :thumbsup::thumbsup: In the olden days wheel bearing grease was the number one choice when assembling an engine. And likely in a repackaged form, still is. :ohmy:


All times are GMT -8. The time now is 05:12 AM.

Powered by vBulletin
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2013 Three Pugs Design - Cut Weld Drive Forums