Cut-Weld-Drive Forums

Cut-Weld-Drive Forums (http://volksrods.com/forum/index.php)
-   The Tech Bin (http://volksrods.com/forum/forumdisplay.php?f=17)
-   -   Beam adjusters install and adjustment instructions (http://volksrods.com/forum/showthread.php?t=28233)

onelowzuki September 23rd, 2009 07:52 AM

Beam adjusters install and adjustment instructions
 
I see questions pop up every now and then about beam adjusters--Here is a pic of the instructions
http://i289.photobucket.com/albums/l...9_28_49_37.jpg

purplemyth January 22nd, 2011 02:09 PM

Re: Beam adjusters install instructions
 
I'm adding this for those it might help~ since the directions to install don't exactly tell you how to adjust.

Quoted from Don at chirco~

Quote:

This should be fairly straight forward.
Jack up the front end a put it on two jack stands, one on each side.
On your adjusters, the bottom screw and nut is the adjustment and the upper puts tension on your leaf springs.
If you tighten your adjustment screws, you will be rotating the springs up, forcing your control arms down and that raises the stance of the car.

Do this adjustment a little at a time to both your upper and lower beam tube, until you get the stance you want.
Then lock down the jam nuts so it stays in place.
http://www.chircoestore.com/catalog/...ach=3307;image

from this thread~

http://www.chircoestore.com/catalog/...26729#msg26729

69rat*tat2r January 26th, 2011 03:43 PM

Re: Beam adjusters install and adjustment instructions
 
becareful that you pay attention so you don't have it turned the wrong way before you weld it in. Then it will raise it... ooops!!!!


All times are GMT -8. The time now is 01:17 AM.

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2020 Three Pugs Design - Cut Weld Drive Forums