Cut-Weld-Drive Forums

Cut-Weld-Drive Forums (http://volksrods.com/forum/index.php)
-   The Tech Bin (http://volksrods.com/forum/forumdisplay.php?f=17)
-   -   Scat bus shifter into bug (http://volksrods.com/forum/showthread.php?t=24310)

bugdust December 27th, 2008 05:49 PM

Scat bus shifter into bug
 
I was just looking in one of the old shifter threads and the question of putting a Scat bus shifter into a bug came up. There was no pics.

There's a couple of ways to put a Scat bus shifter into a late bug (68+). It may be the same for earlier cars as well. I put one in a 69 bug a few years ago. This is all from memory and a few pics so bear with me.

The Scat bus shifter is about 1" longer below the mounting plate than the bug but has a 3/8" spacer (two "horseshoes") tacked on there so it comes out to about 5/8" difference. You could just add a couple spacers under each bolt location or a stack of washers I suppose, but that's not how I did it. I made a 1" spacer.

Here's a pic of the difference after I knocked the spacers off.
Bug on top, bus below
http://img.photobucket.com/albums/v2...t_shifters.jpg
spacers removed
http://img.photobucket.com/albums/v2...shifters_2.jpg

I took a piece of 1" thick flatbar (1x3 maybe, about 6" or so long) and layed out the outline of the bottom of the Scat shifter on it. I cut it to shape, including the center hole. Make the hole bigger than the Scat hole to allow for the shaft angles or bevel the sides.
http://img.photobucket.com/albums/v2...9/spacer_1.jpg
http://img.photobucket.com/albums/v2...9/spacer_2.jpg

I cut it out by hand with a torch.

Then, I just drilled some slots into the plate to allow some adjustment and bolted it up with longer bolts.
http://img.photobucket.com/albums/v2...alled_base.jpg
http://img.photobucket.com/albums/v2.../scat_boot.jpg
http://img.photobucket.com/albums/v2...t_in_bug_4.jpg

I sold the car with the shifter & spacer in it so I can't get any actual dimensions for you. I still have the paper template somewhere.

jkien65 December 27th, 2008 06:18 PM

Re: Scat bus shifter into bug
 
Nice tech. Needs to be in the tech bin.


All times are GMT -8. The time now is 12:30 PM.

Powered by vBulletin
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2013 Three Pugs Design - Cut Weld Drive Forums