View Single Post
Old October 11th, 2010, 10:49 PM   #13
markh
Forum Member
 
markh's Avatar
 
Join Date: Jan 2008
Location: Vancouver, WA
Posts: 661
Default Re: 1937 Volkster convertible

Heading back to the rear decklid, got distracted by the area between the rear fenders. So, cut out a few pieces of metal and started to form a rollpan.

The reason behind the giant addition was to help me hand bend it under.

With the general shape I want, I take a magic carpet ride over to microsoft paint,,and I hope to have the rear lower edge look like this when all done:

There is a whole lot of contour to the outer edges of the pan area. Not noticeable in the photo, but it's there. A lot of material used to make a simple bend, I know. I may decide instead of a straight line across, to add a slight radius. The license plate and LED tail light strips will go down there somewhere. Yet to be determined.
markh is offline   Reply With Quote