View Single Post
Old June 11th, 2008, 08:39 PM   #8
Forum Member
metalmaster1766's Avatar
Join Date: Aug 2007
Location: Cincy, Oh
Posts: 3,570
Member Photo Albums
Default Re: Ron's 66 Bug project

not much, but i did push it out of the shop, wiped all the dust off it, then pushed it back in and started cutting parts to fab up the rear axle mounts

cut some square tube for the trailing arms, then some smaller round tube to use as diagonal upper arms, im planning on using a 4 link diagonal setup in the rear

i have the body off as of tonite, i hope to have most of the fab work done so i can get the axle in by next weekend,

then its all down hill from there,

a few picstures

thats all for now
"Can't" is a word that means your to lazy to even try.


Last edited by metalmaster1766; August 5th, 2008 at 05:34 AM.
metalmaster1766 is offline   Reply With Quote