View Single Post
Old April 30th, 2009, 04:30 AM   #9
Forum Member
Scott76's Avatar
Join Date: Mar 2007
Location: Fleetwood, PA
Posts: 3,964
Member Photo Albums
Default Re: Fleetwing Camper Build

Picked the bearing seals up yesterday (upgraded the seals too). I cleaned the spindles off and put the new upgraded brake assemblies on. The have galv. backplate and stainless steel springs and the cylinder is coated. Yea its over kill but the price difference between the standard and the upgrade was like $5. Thats a no brainer to me. I'll never have to worry about them. I cleaned the huds and put the bearings in. Mounted the hubs and adjusted the brakes. put the wheels on. Installed the step to see how it looked. I bedlined the step with low air pressure to get a rough coat, so no skid tape is needed.

Bugger Off

Fleetwing Camper

Going to the Basement
Scott76 is offline   Reply With Quote