Thread: Swing to IRS
View Single Post
Old January 24th, 2005, 09:02 AM   #14
jimw
Forum Member
 
Join Date: Dec 2002
Posts: 46
Default

[attachmentid=3265] The fixture was made off an IRS chassis. There is a piece of plate with the
torsion cap bolt pattern in it. The other end is a piece of round tube bored
to a good fit for an IRS pivot bolt. These pieces were assembled into the
IRS chassis and angle and flat bar as shown in the pics were used to connect
them together. Once welded up it can be unbolted from the chassis and used
as a jig to locate the brackets on a swing axle chassis. Just requires some
carefull cutting to fit.
You have to make one for each side.
Jim
jimw is offline