View Single Post
Old January 24th, 2010, 05:35 PM   #68
Palepainter
Forum Member
 
Palepainter's Avatar
 
Join Date: Nov 2005
Location: Lafayette, CO
Posts: 1,344
Default Re: My concept for the general Vee

Finished up all the welding on the driver side. Cut out a few rust repair areas that will have to wait until the pan is separated from the body. I backed the car out of the shop and turned it around then started the passenger side mods. I capped off the B pillar and started the new rear sail panel.




Looking forward to getting the inner supports cut out and then mounting up the beam extender and finishing off the front apron area. Then I will mount up the motor in order to finish up the rear apron before separating the chassis and body. My plans are to powdercoat the entire undercarriage.

__________________
http://www.mikelearn.com

Last edited by Palepainter; January 24th, 2010 at 05:39 PM.
Palepainter is offline   Reply With Quote