Cut-Weld-Drive Forums

Go Back   Cut-Weld-Drive Forums > The VolksRodders Forum > The Tech Bin

The Tech Bin An ARCHIVE of helpful and informative tech posts...


User Information
Your Avatar

Stuff to check out...

Cool stuff you NEED!

Forum Stats
Members: 17,471
Threads: 32,236
Posts: 544,719
Total Online: 469

Newest Member: dconrads

Latest Threads
- by yimbo
- by JiI

 
Reply
 
Thread Tools Display Modes
Old June 19th, 2011, 07:11 PM   #1
whozawhat
Forum Member
 
whozawhat's Avatar
 
Join Date: Oct 2008
Location: Xilbalba
Posts: 125
Default Zenith 32NDIX Float Level Gauge
Re:: home made tool   

Zenith 32NDIX Float Level Gauge

Anyone that has worked on Zenith 32NDIX carbs has seen the expensive $138 tool for checking the float level with the carb assembled.


If they search a bit they may have seen the $69.00 tool that they could get. I am cheap if I think I can make something to do the job. (with thanks to precisionmatters )

I have a spare float bowl plug so I drilled a small hole the same size as the plug I.D. (about 5/64) from the inside through the cap.
Then I counterbored the outside using a 3/16 drill bit, don't go to deep. It is to fit a piece of 3/16 steel brake line.


Find an o-ring the correct size to replace the regular sealing washer on the plug. This will let it seal without having to tighten it too much.

Screw the plug into the carb until it is firm on the o-ring and mark which side is the top.

Remove the plug, remove the o-ring and solder in a piece of bent brake line, make sure the bend in the line points up to the top mark on the plug before soldering, don't cut it off untill after it is soldered because the extra tube makes a good handle.
Make sure the passages are clear after soldering you may have to heat it up and blow through the tube if you have soldered it closed.



Cut it short and fit some clear tube,



Make a bracket to hold the line upright, I used a choke arm from one of the spare carbs. The bracket fits under a cover screw.

The measurement from the underside of the bracket to the fuel level is 1.05 "
This picture is with the engine running.

Cost,????

Last edited by whozawhat; July 2nd, 2012 at 12:08 PM.
whozawhat is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump



All times are GMT -8. The time now is 04:17 AM.


Powered by vBulletin
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2013 Three Pugs Design - Cut Weld Drive Forums