4x4 v8 midengine T2 bus
G'day all. I'm from the sunshine coast north of Brisbane Queensland Australia I have been lurking for awhile. I'm in the process of building a T2 bus with a 3.9 litre roverv8 behind the front seats backed up by a Toyota Hi Ace diesel 5 speed & Nissan 720 transfer case. I have spread the front beam tubes by 80mm to allow the rodeo front spindles room to fit in for the 4x4 drive to the front. I'm using Holden v8 commodore IRS diff centres the rear is LSD 3.08 ratios the rear suspension is standard bus with 12mm spacers between the hub carrier & the spring plates to allow for the wider diff & the adapters required to bolt the bus CV joints to the diff centre on the rear I'm using Mitsubishi Pajero rear disc assemblies that with work are a bolt on fit no welding if there's interest I will post some pics from the beginning
|
Linear Mode
