Cut-Weld-Drive Forums

Go Back   Cut-Weld-Drive Forums > The VolksRodders Forum > Members Intros and Project Updates!

Members Intros and Project Updates! New member introductions and project updates...
Your ongoing "journals"...

User Information
Your Avatar

Stuff to check out...

Cool stuff you NEED!

Forum Stats
Members: 17,564
Threads: 32,386
Posts: 547,521
Total Online: 582

Newest Member: Tylerted

Latest Threads
- by RichG
- by 1slo3
- by 1slo3

Thread Tools Display Modes
Old June 17th, 2010, 11:20 AM   #1
Forum Member
Join Date: Jun 2010
Location: San Jose ca
Posts: 10
Cool New to the coalition And need assurance

Hi my name is Olague I have a 1969 vw beetle I can post pictures of it later. I am from san jose ca and this is the 1st time that i have attempted to work on a car as in engine repair and car modifications, so everything is new to me. So far i have gotten my dual port engine to run and now i am looking into chopping the beetle 3 inches, i want it to look like a chop but not be completely that low. I have purchased a oval window section to install as well.

I was reading the top chop measure form and i wanted some help, i just want to make sure I know what pillars are which.

Pillar A is the pillar that holds the front windshield correct?
pillar B is the pillar with the door frames
pillar C is the rear section

Am I correct?

and according to that same post for my 3 in cut these
are my measurements

A= 3.75
B= 3
C= 3.99

Thank you guys for the help :)
Olague is offline   Reply With Quote

3inch chop top, chop, chop top, help chop, olague

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT -8. The time now is 01:22 AM.

Powered by vBulletin
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
ALL text, images, graphics and content herein are Copyright 2002 - 2020 Three Pugs Design - Cut Weld Drive Forums