2 British Armored Personnel Carrier Seats - Cut-Weld-Drive Forums

UT-X · June 7th, 2011, 06:49 AM

Selling 2 RARE British Armored Personnel Carrier seats. I was told they are from the late 1950s. The seats are mounted on new Speedway Motors sliding brackets with about an inch to the front legs of the brackets to give the seats a little backward lean - they were a little too flat before. My top is chopped around 4-1/2 inches and these seats are the perfect height. The seats still have their original light green paint (patina no additional charge) but I was considering media blasting them and running them raw. I believe the seats are aluminum. As you can see from the pic, the seat backs fold forward.

PM me with questions!

UT-X · June 12th, 2011, 06:28 PM

Gettin a lot of questions about this so here are the dimensions:

- Seat (where ya plant your butt) to floor is 8.5" in the front (about 7" in the back).
- From the floor to the top of the seat back is 26"
- Seats are 16" wide at widest point (on the bottom)
- 18" long at the longest point (again the bottom).

These will mount directly to the pan without any modifications other than 4 bolt holes (probably best to remove original seat mounts).

UT-X · July 5th, 2011, 11:52 AM

Sold to Type3tom!

Thanks Tom & don't forget to post pics when ya get 'em in.